Description The Muc-Off Tubeless Sealant Kit contains everything needed to get a tubeless-ready wheelset set up and ready to roll. HOW TO USE THE MUC-OFF TUBELESS SEALANT KIT Remove all old rim tape and clean rim. Make sure the rim is clean and dry before applying tape. Line the tape up from the opposite side of the valve. Start by unwinding a small amount of the tape and pressing it down using your thumb or finger to hold pressure down. Continue to hold while you pull back on the tape and stick down tight once you have a few cm on the tape will stick and holding is no longer needed. Continue the entire way around the rim (if it has a big concave in you can pull and wiggle the tape to fill any edges) Overlap the tape by roughly 10 – 15cm Leave a small amount unstuck so that you can cut the remainder off Once cut stretch and pull the tape down to create a seal Go around the rim with your thumb to make sure there is no air pockets or missed areas. Once your happy with how it looks using a small pin locate the valve hole and cleanly pierce the tape ready for the valve Grab your tubeless valve and remove the lock ring and o ring Choose the right rubber fitment for your rim tape and insert valve into rim Refit O-ring and Lock ring making sure you lock the valve in (don’t go too tight or you could damage the rubber) Re-fit your tyre of choice careful not to damage the tape (by using tyre levers etc) Inflate tyre to create a seal (should hear some popping around the rim) Release Air and remove valve core using the spare valve cap Grab the sealant pouch and give it a shake Unscrew the cap and fit on the valve in an upright position While holding the pouch spin the wheel downward so that the pouch is now upside down Insert the sealant by rolling the pouch down Spin wheel back upright and remove pouch Reinsert valve core and inflate to your pressure WHAT’S INCLUDED IN THE MUC-OFF TUBELESS SEALANT KIT? 1x Pouch of No Puncture Hassle Tubeless Sealant (140ml) Valve core removal tool 15ml measuring scoop